Resetting the Maintenance Light. Turn the ignition to the On position. Set the odometer to trip A by pressing the trip control button in the bottom right corner of the instrument panel. Turn the ignition off. Press and hold the trip control button. Turn the ignition to the On position without releasing the trip control button.
Maintenance Light Reset Guide With Cluster Button . In this section, we’re gonna reset the oil life or the maintenance minder whatever you wanna call it on the Honda CR-V. Here we will reset it using the Trip knob on the instrument cluster. So this is what you have to do: Turn on the car without cranking the engine
3. Turn the key to OFF. 4. Place your finger back on the odometer button, press and hold. Then while still holding the button, turn the key back to "On" (not START). 5. Hold the odometer button in until the MAINT REQD light goes outshould take about 8-10 seconds. Follow these engine oil life reset instructions for your Honda Accord: Turn the ignition on (do not start the engine). Display the engine oil life by repeatedly pressing the SELECT/RESET button. Press and hold the SELECT/RESET knob for more than 10 seconds. The engine oil life indicator and the maintenance item codes blink.
Today we show how to reset the Service Light on a Nissan Titan. Please press the like button if it was helpful!CheersDisclaimer: The information contained in
First, with the engine off press and hold the TRIP button on the instrumen cluster. Then turn on your car. Keep hold that knob until the wrench light flash and then it’ll go away. So that’s how you reset the wrench light on your Mazda CX3. If you have any troubles with doing that, feel free to come in and see us here in the clubhouse, and Go to the Oil Life screen. When things light up on your dash you need to push the selector button which is right here and go through until you get to the Oil Life. Press and hold the knob. In order to reset this, you push and hold the button for 10 seconds until it flashes. Depress the knob again. Turn your Ignition to the “I” position. Put your keys in the ignition and turn them to the first position, usually marked as “I”. [1] This will turn the electricity on in your car, but not the engine. 2. Click the odometer reset button until it says “Trip A,” then hold it. Change the odometer so it reads “Trip A.”. Step-by-Step Procedure. 1. Place the “on” position of the key in the lock. Remove your foot from the brake pedal and make two presses of the Start button. 2. Have the screen display the TRIP A image. By pressing the ODO/TRIP button or the oil maintenance reqd reset button, you can get the display to show the TRIP A. 3. Once you get to the Settings you’re going to go to the OK button. Scroll down and select the MAINTENANCE. Next, you’re gonna use the button to scroll down to get to MAINTENANCE and press OK. Select the OIL AND FILTER. After that, you can see the OIL and FILTER, so go ahead and press the OK button again. Highlight and select RESET.
Here are the steps on how to reset 2013 Toyota Corolla Maintenance Light : Put the key in the ignition. Turn to the “ON” position. Depress the odometer button until your dash readout shows TRIP A. Switch the car OFF but keep the odometer button held down. With the odometer button held down, turn the key to the ON position again.
